Ipsec Tunnel Between Cisco And Juniper

Ipsec Tunnel Between Cisco And Juniper. On the cisco side, i can do: The configuration steps on the ssg are the following:

Cisco ASA 5508X VPN/IPSEC with BGP Tunnel Route XP
Cisco ASA 5508X VPN/IPSEC with BGP Tunnel Route XP from www.routexp.com

Here is the config of srx side: I’m just looking through this document about juniper srx to cisco ipsec tunnel. And since the juniper firewall can ping an ipv4 address on the remote side.

Show Activity On This Post.

An ipsec tunnel is created between two participant devices to secure vpn communication. We discussed the requirements for the ipsec vpn. You must need the static routable ip address to establish an ipsec tunnel between both the routers.

A)Route Based Tunnel Config And, B)_Policy Based Tunnel Config.

On the juniper side, there is: We have multiple sas in that tunnel as we have allows only few individual servers to communicate with our servers. Gateway with preshared key and p1 proposal.

Cisco Asa Log States That.

Juniper srx 210 (junos 10.0r1.8) red firewall: Show crypto ike sa show crypto ipsec sa. Ipsec between juniper srx and cisco asr1002.

Show Security Ike Sa Show Security Ipsec Sa Show Security Flow Session.

This document outlines the configurations necessary to build an ipsec tunnel with ikev2 between a cisco asa and a juniper ssg. It wasn't too difficult to make the leap from ikev1 to ikev2, however there were. Customer complains that ipsec tunnel is getting disconnected in between.

These Are The Commands For The Cisco Cli.

No matching crypto map entry for remote proxy b.b.b.b/255.255.255.0/6/0 local proxy z.z.z.z/255.255. And since the juniper firewall can ping an ipv4 address on the remote side. I found a fair amount of documentation on the web that used ikev1, but ikev2 between the two types of devices was not well documented.