How To Reset Cisco Air-Cap2602I-A-K9

How To Reset Cisco Air-Cap2602I-A-K9. You can find the guide here: Hold the mode button down for approximately 20 seconds while powering up the access point.

5x New Cisco AIRCAP2602IAK9 Wireless Access Point
5x New Cisco AIRCAP2602IAK9 Wireless Access Point from www.ebay.com

While i am not familiar with cisco's products, i did do a quick search and i was able to find a configuration guide from cisco for your ap. Hpe aruba access points antennas. This will bolster support for the growing performance and.

Step 1 Make Sure That The Cisco Wireless Lan Controller Ds Port Is Connected To The Network.

This will bolster support for the growing performance and. However i've run into a slight issue. For businesses yearning for easy and reasonable upgrades for the new 802.11ac wave 1 standard, the cisco aironet 2600i access points are the perfect solution, providing theoretical connection rates of up to 450 mbps.

Once Added To My Devices, They Will Be Displayed Here On The Product Page.

Ether_init initializing ethernet port 0. This product is no longer supported by cisco. While holding down the button reset, turn on the power to the unit again and hold for another 30 seconds

I've Followed The Instructions In The Product Sheet Using The Mode Button To Perform A Hard Reset To Factory Settings, But It Doesn't Seem To Be Working.

The cap in the model number says that it was shipped from cisco with the controller based software image. Issue the flash_init command and the load_helper command: Each time they boot like normal, and still require the login credentials that were previously set up.

With The Ap Unplugged, I've Pressed And Held The Mode Button And Inserted The Ethernet Cable.

I have this access point that has been placed in to a download loop (that issue is being rectified next week). I have tried cisco/cisco, admin/cisco and various other combinations, but nothing is working. Hpe aruba access points antennas.

The Cisco 2600I Access Points Offers Unmatched Application Performance And Speed.

But after connecting via serial cable, it is still asking for username and password. Cisco antenna 2.4 5 5.8 ghz. Click this url to browse to complete access point mounting instructions: