How To Reset Cisco 2950 Switch

How To Reset Cisco 2950 Switch. When the router boots up it loads the 'startup configuration'. Connect up your console cable and power on the switch, whilst holding down the “mode” button:

Cisco Catalyst 2950 Series 48Port Wired Switch WSC2950G
Cisco Catalyst 2950 Series 48Port Wired Switch WSC2950G from www.ebay.com

If indeed the switch has a mode button on the front panel, step 1: When the router boots up it loads the 'startup configuration'. This example shows how to reset the configuration on the switch to factory defaults:

Reset A Cisco Switch 2960 To Factory Default Settings.

This is example, we are going to be using a cisco 2950. In this video i show you how to reset a 48 port cisco switch by holding the mode button for about 30 seconds to a minute. So here is how you do it.

To Factory Reset Your Switch You Will Need To Issue These Commands:

This interrupts the boot process before the flash file system can initialize, and after a short while (continue holding the “mode” button) you will see the following prompt: Connect up your console cable and power on the switch, whilst holding down the “mode” button: Connect the blue console cable, and open a tty session:

Boot Into A Password Recovery Mode.

Connect up your console cable and power on the switch, whilst holding down the “mode” button: Then, reset the switch to factory defaults with use of the procedure in the reset catalyst switches running cisco ios software section of this document. Plug in/turn on your cisco switch while simultaneously holding down the mode button on the front of the unit.

Cat5K> (Enable) Clear Config All This Command Will Clear All Configuration In Nvram.

Hold down the mode button on the front of the switch and power. To change the configurations of the switch, we will need to connect to the switch through the console terminal. Connect your pc to the cisco switch via your console cable.

This Example Shows How To Reset The Configuration On The Switch To Factory Defaults:

So here is how you do it. When the router boots up it loads the 'startup configuration'. Open putty or your other serial program and connect.