How To Delete Loopback Interface Cisco

How To Delete Loopback Interface Cisco. A loopback interface is a virtual interface that doesn't correspond to anything physical in the router. Using the “no” command on each line to remove the configuration can be tedious and cumbersome.

Setting up a Loopback Address YouTube
Setting up a Loopback Address YouTube from www.youtube.com

You may connect via the ip address of the loopback interface, if there is still a route to the loopback interface (in this case via interface fa0/1). The vpn template form appears. What do we need cisco loopback interfaces for, anyway?

Note That When You Configure An Ip Address For A Loopback Interface, You Do Not Specify A Network Mask.

By the way, in nokia routers. Using the “no” command on each line to remove the configuration can be tedious and cumbersome. You may connect via the ip address of the loopback interface, if there is still a route to the loopback interface (in this case via interface fa0/1).

A Loopback Interface Is A Logical, Virtual Interface In A Cisco Router.

Here, the key word “loopback” is important. Loopback interfaces never gose down, just if the router will go, but and hardware interface, might go cause of differents factors, cable, human errors, etc. To create or access a switch virtual interface (svi) and to enter interface configuration mode, use the interface vlan command in global configuration mode.

Use The Default Command In Global Configuration Mode To Clear The Interface Configuration And Restore The Interface To The Defaults.

Loopback interfaces emulate a physical interface. To show a specific interface that is currently in loopback operation, use the show interfaces loopback exec command. A loopback interface is always up and allows border gateway protocol (bgp) neighborship.

The Default Subnet Mask 255.255.255.255 Is Used.

And from that router itself, you can telnet (or ssh) to the router, as in this case, htere is a connected route to the loopback ip address. The vpn template form appears. A loopback interface has many uses.

You Can Ping The Loopback Interface To Verify That.

Loopback interfaces can act as a termination address for routing protocol sessions. The loopback interface is very useful in a testing environment and it’s not assigned to any physical port, for example, it could be used for testing internal routing. In my router config i have configured 2 loopback interfaces loopback0 and loopback9 as follows.