Configure Static Route Cisco Router

Configure Static Route Cisco Router. If we want r1 to forward packets to subnet 2.0.0.0 then we need to configure a static route. In order to configure static routing in cisco ios routers, this is the command to use.

Konfigurasi Static Routing di Cisco Packet Tracer YouTube
Konfigurasi Static Routing di Cisco Packet Tracer YouTube from www.youtube.com

Configuring routing on the router r1. R1 (config)#ip route 192.168.10.0 255.255.255.0 10.1.1.2 r1 (config)#exit r1#. The format of a static route command on a cisco asa firewall is:

Configuring Routing On The Router R1.

Asa(config)# route [interface name] [destination network] [mask] [gateway] now let’s see the commands needed for each router. Router(config)#ip route 10.0.0.0 255.0.0.0 40.0.0.1 router(config)#ip route 30.0.0.0 255.0.0.0 50.0.0.2 router(config)#exit router#show ip route static s 10.0.0.0/8 [1/0] via 40.0.0.1 s 30.0.0.0/8 [1/0] via 50.0.0.2 router# First run the command show ip route to view the ip routing table for router b before defining static routes routerb# configure terminal routerb(config)# ip route 10.10.11.0 255.255.255.0 10.10.10.1 routerb(config)# ip route 10.10.13.0 255.255.255.0 10.10.12.2 routerb(config)# exit

R1#Conf T Enter Configuration Commands, One Per Line.

If we want r1 to forward packets to subnet 2.0.0.0 then we need to configure a static route. (optional) to remove only one static route to the given subnet via the given next hop, enter the following: Router (config)#ip route 192.168.1.0 255.255.255.0 10.1.1.2.

To Configure A Static Route, See The Following Section:

However, in some cases the default gateway might not be able to reach. It is not possible to configure correctly unless you have a good grasp of the network that should be registered in the routing table for each router based on the overall image of the network. Configuring static route on r2:

The Following Image Shows How To Run These Commands In The Packet Tracer.

Run the following commands on the router r1 from the global configuration mode. Now add a static route to the routers so that pc0 can communicate with pc1. Router>enable router#configure terminal enter configuration commands, one per line.

To Specify That An Administrative Distance (Ad) Of 200 Has Been Assigned To A Given Route, Enter The Following Command, For Example:

This is something people often forget configuring static route for the first time. Static route is a configuration method in which route information (network address/subnet mask, next hop) is registered by entering commands for each router. You can configure a static route in a vrf.