Cisco Rip Passive Interface Command

Cisco Rip Passive Interface Command. Let’s use the passive interface command to disable the hello packets towards the switch: These older protocol miss the state machine concept so they still accept routing updates heard on a passive interface.

PPT CCNA Cisco Certified Network Associate Study Guide
PPT CCNA Cisco Certified Network Associate Study Guide from www.slideserve.com

You can do this from router configuration mode using the following command: By default, rip sends updates on all interfaces on which rip is enabled. Also if you make the ospf network statements specific for an interface then you can control which interfaces you enable it on:!

Passive Interface Command Rip Hold Down The Propagation Of Rip Broadcasting In A Router.

You can prevent rip from sending updates via loopback0 by configuring loopback0 to be a passive interface in the rip routing process. These older protocol miss the state machine concept so they still accept routing updates heard on a passive interface. To prevent this from happening, the passive interface command is used:

Let’s Use The Passive Interface Command To Disable The Hello Packets Towards The Switch:

This example shows how to configure an etherchannel with lacp mode as active. To reenable the sending of routing updates, use the no form of this command. Command qualified for use in cisco vmanage cli templates.

This Command Changes The Configuration Logic To A Default Passive;

Actually i found this on the cisco site use of the command ‘passive interface fa 0/0’ under ‘route rip’ ensures that broadcasts are not sent out but the network is still included in the rip database. Setting an interface as passive disables the sending of routing updates on that interface, hence adjacencies will not be formed in ospf. Note that it still listens on a passive interface, which may be a security issue if somebody is trying to poison your routing table

The Same Applies To Ripv2

Passive interface command is used to suppress ospf hello packets on a specified interface. Also if you make the ospf network statements specific for an interface then you can control which interfaces you enable it on:! Now, the rip process will no.

By Default, Rip Sends Updates On All Interfaces On Which Rip Is Enabled.

It is also used in other routing protocols like rip and eigrp. 7 rows starts the rip routing process. You can use the passive interface default command to make all interfces passive, then enable rip on the individual interfaces that require it:!