Cisco 2800 Reset Factory Default

Cisco 2800 Reset Factory Default. So i followed instruction from this site: If you want to keep the configuration, but reset the password, it is just a few more steps.

Cisco 2800 Series Router Flash Replacement YouTube
Cisco 2800 Series Router Flash Replacement YouTube from www.youtube.com

Release the reset button after 10 seconds. So i followed instruction from this site: Using driver version 1 for media type 1 base ethernet mac.

This Interrupts The Boot Process Before The Flash File System Can Initialize, And After A Short While (Continue Holding The “Mode” Button) You Will See The Following Prompt:

This should bring you to the rommon prompt 4. Turn off your router and then turn it back on. Here is a document that goes over the led status:

Find The Reset Button On The Router.

You should now see a router(config)# prompt. At the router> prompt, type enable; Type write erase to issue the erase comment.

Power Off The Router And Then Power On.

The prompt changes to router#, indicating that the router is now in privileged mode. Connect to the serial console. Type y to confirm erase command.

To Reload The Router, Issue The Reset Command, As Shown In This Example:

Reset cisco 2800 router to factory settings : You’ll have to enter the admin password to perform the factory reset (the default password: Release the reset button after 10 seconds.

Or Proceed To The Phone Menu > Settings > Advanced Settings > Enter The Phone Password (The Default Password:

Press 4, 6, 8 and * keys and hold them. If you want to keep the configuration, but reset the password, it is just a few more steps. To enter config mode, issue the config terminal command.